0-10VDC from PLC to PWM

Compact DIN Rail Analog Converter with Integrated LCD (OLED) Display

This module converts any analog signal 0 to 10 volts DC to PWM (Pulse Width Modulation).

Product dimensions: 43 x 75 mm. (approx.).

Key Features:

• Power from 12 Volts DC or 24 Volts DC or any range between 11 to 29 Volts DC
• The PWM output is highly configurable:
  • Frequency can be adjusted between 50Hz and 10 kHz.
  • Output up to 2Amps current.
    • Optionally output can drive 8 Amps (additional heatsink)
  • Output minimum and maximum duty cycle is configurable from 0% to 100%.
  • Output can be inverted
  • Output rate of change can be limited (slow start / slow stop) to prevent hydraulic systems damage
  • Manual override to control the output
• Space-Saving Design: Ultra-compact module with a width of just 43 mm.
• Easy-to-Use LCD Display: Real-time temperature monitoring and settings adjustment via a user-friendly integrated LCD screen.
• Customizable Options:
  • We design and maintain this product.
  • We can program it to your requirements.
  • On request, alternative output ranges (-10..+10v, 0..5v, 0-10v) are available.
  • Single input – multiple output possible

Terminal block

• TB-1: Power Supply PLUS (+) 12 to 24v DC +- 20%
• TB-2: Power Supply MIN (-)
• TB-3: Addon A1
• TB-4: Addon A2
• TB-5: Addon A3
• TB-6: Addon B1
• TB-7: Addon B2
• TB-8: Addon B3

Converting analog 0…10vDC to 4-20mA current loop

For converting a 0-10 volt analog signal to 4-20mA, this module can be used. The current loop 4-20mA output is fully galvanic isolated from the power supply and the analog input. Use the common terminal block connection except:

• Attach the 0..10v analog voltage to TB-4 (analog signal input #1) and use TB-5 as common ground.
• Attach the 4-20mA analog current loop output to TB-7 and TB-8 where the TB-7 is the PLUS and TB-8 is the GND. Both terminals are galvanic isolated from the power supply and analog input.